Treon Industrial Node 6 Default Configuration

Legacy documentation

This page is preserved from the previous knowledge base and describes older Treon products and manual configuration workflows. It is kept for reference and is not maintained against current Treon Connect releases.

This article shows the default configuration of the Treon Industrial Node 6.Fig.: Treon Industrial Node 6 DM Model.

Please note: The configuration shown here is valid for FW version 6.17.X and up. For the older configuration default please check Here.

Timer Parameters

	Time	ON/OFF	Measurement Selection
Timer 1	1h	ON	0
Timer 2	6h	ON	1,3
Timer 3	5m	OFF	0
Status Interval	3h	ON	none

Measurement Parameters

Measurement ID	0	1	2	3	4	5	6	7
Axis	3	3	x-axis	x-axis	3	3	x-axis	x-axis
G-Range	4	4	4	4	4	4	4	4
Sample Amount	26667	32768	57344	90112	36864	18432	110592	26667
Calculations	0 and 1	2 and 3	4	5	10	10	10	10

Calculation Parameters

CalcID	0	1	2	3	4	5	6	7	8	9	10	Default
Features	a-RMS, a-PEAK, a-P2P, Kurtosis, Crest	v-RMS, v-PEAK, v-P2P	FFT	FFT	FFT	FFT	FFT	FFT	FFT	a-RMS, a-PEAK, a-P2P	Raw data	a-RMS, a-PEAK, a-P2P, FFT
Low cut-off	0	2	0	2	2	2	0	0	0	0	0	0
High cut-off	6666,7	1000	6666,7	1333,5	740	494	no filter	740	494	no filter	no filter	no filter
Decimation			2	8	14	22		14	22
Averages			4	0	0	0	8	0	0			0
Overlap %			50%	0	0	0	50	0	0			0
Window			Hanning	Hanning	Hanning	Hanning	Hanning	Hanning	Hanning			Hanning
Lines of resolution			1600	1600	1600	1600	1600	1600	1600			1600

Wakeup Parameters

	Default
Feature Enable	OFF
Wake-up G-range	4G
Wake-up threshold	1
Wake-up Action Delay	5s
Wake-up Blank-time	3600s
Action measurement	ON
Action Indication	ON
Measurements to be triggered	0