settings

Introduction to Device Management Commands

Introduction Treon products, from the Treon Gateway to Treon Industrial Nodes within a mesh network, can be addressed via device management (DM) commands. These DM commands can be used to acquire information from the products, to change their configuration and to update them.

Device Management with DM Commands - Full Guide

Introduction Treon products, from the Treon Gateway to Treon Industrial Nodes, within a mesh network can be addressed via device management (DM) commands. These DM commands can be used to acquire information from the products, to change their configuration and to update them.

Device Management Specifications for Treon Industrial Node

Introduction The Treon Industrial Node measures vibration and temperature of the machine or structure it is attached to. The behaviour of the sensor can be modified by device management commands using Treon JSON DM messages.

Device Management Specifications for Treon Industrial Node 6

Introduction The Treon Industrial Node 6 measures vibration and temperature of the machine or structure it is attached to. The behaviour of the node can be modified by device management commands using Treon JSON DM messages.

Wake-Up

Wake-Up The Treon Industrial Node, Treon Industrial Node 6 and Treon Industrial Node 6 EX all can be configured to continuously sample at low ODR and trigger a proper measurement when it detects a vibration exceeding a determined parameter.

CBOR

CBOR CBOR is a data format based on JSON that we use to compress some of our newer features. CBOR resources on the Gateway use DM messages with “Ver”:“2.1” instead of “Ver”:“2” to differentiate from the plain JSON type messages.

CBOR Gateway DM Node Wirepas Parameters

; COSE encrypt payload? wp-params-tagged = #6.400(wp-params) wp-response-tagged = #6.401(wp-response) wp-responses-tagged = #6.402(wp-responses) ; Node wirepas parameters wp-params = { "remote-command": { ; target-addresses and target-ids mutually exclusive ?"target-addresses": [*uint], ; Target ids as hex strings ?

CBOR Node Inventory

nodes_tagged = #6.33584(nodes) nodes = [* node] node = { "wirepas-id": uint "type": "asset-node" / "asset-sensor" / "ind-node" / "ind-node6" / "unknown" "last-message": uint ; Epoch seconds ?"serial": tstr ?"profile": uint ; Relevant for asset node/sensor ?