beginner

Wirepas 5.3 Notice Only Gateways with firmware 7.3 or higher can use Wirepas 5.3. Wirepas 5.3 is an incremental improvement in the quality of the wirepas connection along with a few bugfixes.

Wirepas 5.3 Notice Only Gateways with firmware 7.3 or higher can use Wirepas 5.3. Wirepas 5.3 is an incremental improvement in the quality of the wirepas connection along with a few bugfixes.

When the battery of your Treon Industrial Node X is about to deplete, it is time to change it. The old battery can be removed and a new one installed immediately.

 Please find the up-to-date QuickStart Guide for the Treon Industrial Node X here in the Downloads tab.  

 Please find information on the Treon Industrial Node X certifications here in the Downloads tab.  

 Please find the up-to-date Treon Industrial Node X datasheet here in the Product information tab.  

This article shows the settings in the Treon Gateway Configuration UI 1.0.0 for Treon Aito Release 6.5.2 for Gateway. Access Point Mode To configure the Treon Gateway via the Configuration UI you need to turn the Treon Gateway into Access Point Mode and connect to it via a browser.

  hbspt.forms.create({ portalId: "6204089", formId: "fbbae817-a5f4-43dd-ac82-fe89fc35de9e" });

Each measurement ID of a Treon Industrial Node corresponds with a different set of settings. Measurement ID 0 standard 3-axial KPI measurement Measurement ID 1 standard 3-axial FFT measurement with low and high filters Measurement ID 2 1-axis FFT measurement, 2-740Hz filter (higher resolution) Measurement ID 3 1-axis FFT measurement, 2-494Hz filter (higher resolution) Measurement ID 4 3-axial waveform (raw data) measurement Measurement ID 5 3-axial waveform (raw data) measurement, low data sample count Measurement ID 6 1-axial waveform (raw data) measurement Measurement ID 7 1-axial waveform (raw data) measurement, low data sample count Please use Measurement ID 0 as a standard.