beginner

Wirepas 5.3 Mesh Network Features

Wirepas 5.3 Notice Only Gateways with firmware 7.3 or higher can use Wirepas 5.3. Wirepas 5.3 is an incremental improvement in the quality of the wirepas connection along with a few bugfixes.

Treon Gateway Configuration UI 2.0.14

Treon Gateway Configuration UI 1.0.0

This article shows the settings in the Treon Gateway Configuration UI 1.0.0 for Treon Aito Release 6.5.2 for Gateway. Access Point Mode To configure the Treon Gateway via the Configuration UI you need to turn the Treon Gateway into Access Point Mode and connect to it via a browser.

Feedback

  hbspt.forms.create({ portalId: "6204089", formId: "fbbae817-a5f4-43dd-ac82-fe89fc35de9e" });

Condition Monitoring Measurements IDs

Each measurement ID of a Treon Industrial Node corresponds with a different set of settings. Measurement ID 0 standard 3-axial KPI measurement Measurement ID 1 standard 3-axial FFT measurement with low and high filters Measurement ID 2 1-axis FFT measurement, 2-740Hz filter (higher resolution) Measurement ID 3 1-axis FFT measurement, 2-494Hz filter (higher resolution) Measurement ID 4 3-axial waveform (raw data) measurement Measurement ID 5 3-axial waveform (raw data) measurement, low data sample count Measurement ID 6 1-axial waveform (raw data) measurement Measurement ID 7 1-axial waveform (raw data) measurement, low data sample count Please use Measurement ID 0 as a standard.

Condition Monitoring Measurements IDs

Each measurement ID of a Treon Industrial Node corresponds with a different set of settings. Measurement ID 0 standard 3-axial KPI measurement Measurement ID 1 standard 3-axial FFT measurement with low and high filters Measurement ID 2 1-axis FFT measurement, 2-740Hz filter (higher resolution) Measurement ID 3 1-axis FFT measurement, 2-494Hz filter (higher resolution) Measurement ID 4 3-axial waveform (raw data) measurement Measurement ID 5 3-axial waveform (raw data) measurement, low data sample count Measurement ID 6 1-axial waveform (raw data) measurement Measurement ID 7 1-axial waveform (raw data) measurement, low data sample count Please use Measurement ID 0 as a standard.

How to configure the ZTE USB Modem MV833V

Introduction Material: https://usermanual.wiki/ZTE/MF833V The ZTE MV833V 50 Mbps Wireless Modem Mobile Broadband 4G LTE Stick provides: • 4G LTE Unlocked GSM Carrier Desbloqueados GSM (Modem Does NOT Work on Verizon Sprint Net10 or Any CDMA Carrier).

Sensors - Treon Asset Node

Introduction The Treon Asset Node is a modern take on asset monitoring. Designed to stand extreme conditions, Treon Asset Node enables monitoring and locating assets in harsh conditions. It measures asset temperature and captures even the highest shocks, making it a highly viable sensor for asset and logistic tracking.

Installation with Treon Nut Adapter

Introduction It is possible to install your Treon Industrial Node and Industrial Node 6 either with or without epoxy. Option A: Nut adapter installation with epoxy:​ Minimum thread length can be less than 9 mm depending on the amount of epoxy​ Node alignment can be done manually​

Installation with Treon Nut Adapter

Introduction It is possible to install your Treon Industrial Node and Industrial Node 6 either with or without epoxy. Option A: Nut adapter installation with epoxy:​ Minimum thread length can be less than 9 mm depending on the amount of epoxy​ Node alignment can be done manually​