Treon Industrial Node 6

Introduction Treon products, from the Treon Gateway to Treon Industrial Nodes within a mesh network, can be addressed via device management (DM) commands. These DM commands can be used to acquire information from the products, to change their configuration and to update them.

Introduction Before and after the deployment of a mesh network, it is important to test and troubleshoot common issues in deployment.  Testing the Network Before you install the physical devices at the deployment site, first perform a dry-run of the system to test if the network runs.

Introduction Before and after the deployment of a mesh network, it is important to test and troubleshoot common issues in deployment.  Testing the Network Before you install the physical devices at the deployment site, first perform a dry-run of the system to test if the network runs.

Introduction Before and after the deployment of a mesh network, it is important to test and troubleshoot common issues in deployment.  Testing the Network Before you install the physical devices at the deployment site, first perform a dry-run of the system to test if the network runs.

Introduction Before and after the deployment of a mesh network, it is important to test and troubleshoot common issues in deployment.  Testing the Network Before you install the physical devices at the deployment site, first perform a dry-run of the system to test if the network runs.

Introduction Before and after the deployment of a mesh network, it is important to test and troubleshoot common issues in deployment.  Testing the Network Before you install the physical devices at the deployment site, first perform a dry-run of the system to test if the network runs.

Introduction Before and after the deployment of a mesh network, it is important to test and troubleshoot common issues in deployment.  Testing the Network Before you install the physical devices at the deployment site, first perform a dry-run of the system to test if the network runs.

This article shows the default configuration of the Treon Industrial Node 6. Fig.: Treon Industrial Node 6 DM Model.   Please note: The configuration shown here is valid for FW version 6.

This article shows the default configuration of the Treon Industrial Node 6 before FW 6.17 Fig.: Treon Industrial Node 6 DM Model.  Timer Parameters Time ON/OFF Measurement Selection Timer 1 1h ON 0 Timer 2 6h ON 1 Timer 3 24h OFF 2 and 3 Status Interval 3h ON none  Measurement Parameters Measurement ID 0 1 2 3 Default Axis 3 3 3 x-axis All G-Range 4 4 4 4 4 Sample Amount 36864 36864 36864 68268 110592 Calculations 1 and 3 2 and 4 5 6 0  Calculation Parameters CalcID 1 2 3 4 5 6 Default Features v-RMS, v-PEAK, v-P2P, Clipping detect LOW FFT, Clipping detect a-RMS, a-PEAK, a-P2P, Kurtosis, Crest, Clipping detect HIGH FFT, Clipping detect Raw data Raw data FFT, aRMS, aPEAK Low cut-off 10 10 no filter no filter no filter High cut-off 1000 1333 no filter no filter no filter Decimation 9 0 1 Averages 0 9 0 Overlap % 0 0 0 Window Hanning Hanning Hanning Lines of resolution 1600 1600 2048 FFT format Variable Variable Auto (no variable)  Wakeup Parameters Default Feature Enable OFF Wake-up G-range 4G Wake-up threshold 8 Wake-up Action Delay 30s Wake-up Blank-time 900s Action measurement ON Action Indication OFF Action LED ON Measurements to be triggered 1