Treon Gateway

Backend - Treon Aito Overview

Treon Aito is the embedded software platform that powers Treon Gateway. It enables smart data collection from a wide range of sensors, on-device processing, and transmitting to any cloud backend. It supports both Bluetooth LE beacons and Wirepas Mesh sensors.

Update your Treon Gateway & Nodes

Welcome to the Treon Knowledgebase Update section! In this guide we show you how to update your Treon Gateway Aito software via an SSH connection.  The latest Treon Gateway Aito software release is 6.

Combining burst fragments into complete bursts

This article describes how to merge burst fragments into complete bursts. Introduction Each burst will have unique1 measurement id e.g: "MeasurementId":225 and burst id e.g: "BurstId":133. You should identify your burst with this information along with SensorNodeId.

Update your Treon Gateway via SSH

This article describes how to update your Treon Aito software via SSH access to your Treon Gateway. Please Note: In case you are not sure which Treon Aito software release you should install, or if you have a custom configuration, please contact Treon Customer Support.

Quick Start - Treon Gateway

How to get started with your Treon Gateway.

Changing the Wirepas Network Parameters of Treon devices

This article describes the procedure to change the Wirepas network parameters of your Treon devices. Please note: This article is for Treon Gateways with a Treon Aito release version of 6.

Configuring the Treon Gateway

Starting the configuration process Press the configuration button (F) until the status light (A) starts blinking. The Gateway becomes a Wi-Fi access point. Using your phone, computer, or tablet, connect to the access point: select treongw1-serialnumber, where serialnumber is the serial number of your Gateway.

Known Issues and Workarounds

This article offers a list of the known issues in the Treon Aito releases that we are aware of and possible solutions and workarounds.   Wi-Fi network not found in Configuration mode Known Issue: If you activate a Wi-Fi network after you already have entered Configuration mode on your Treon Gateway, it might not be recognized by the gateway.

Sensors - JSON Data Description

This article describes the JSON formatted sensor data sent from Treon Gateway to the backend. IoT-devices like the Treon Node, Treon Industrial Node and Treon Asset Sensor send their measurements as binary data via the mesh network.

Treon Gateway - Factory Reset & Disposal

This article desribes how to delete all of your specific data from the Treon Gateway in order to recycle it at its end-of-life.  Delete Data At the bottom of your Treon Gateway you will find a button you can press to perform a ‘factory reset,’ meant to be performed only before disposal of the device.